|
 |
Lateral & D.P. Positioning Block (NR-1)
Price: $95.00
|
These wooden blocks are designed by Dr. Redden to offer you a consistent means of obtaining precision positioning of the digit for the lateral and D-P views. Dr. Redden strives to obtain all the information possible from his film and he has developed a very methodical, disciplined protocol designed for every radiographic examination. The wooden positioning block has multiple uses and offers many valuable diagnostic positions.
Unique features of the blocks:
- Sold as singles or pairs as requested. Dr. Redden finds using two blocks assures accurate representation of radiographic balance (extremely valuable views for farriers).
- Two blocks simplifies the task of radiographing extremely lame horses. The sound foot can be quickly set on one block and the other foot follows.
- Block height is specific for each machine. Primary beam height should be approximately 3/4 inch (19.05mm) over the top of the block. This assures a true lateral offering accurate sole depth measurement, palmar angle, medial – lateral balance and, distal horn – lamellar zone. Exception: Saddlebreds, Walking Horses or others with a package or exceptionally long hoof capsule.
- Cross wire imbedded in the face of each block clearly delineates the ground surface in the lateral projection and also D-P view; very helpful load zone marker for the bare foot. Dr. Redden uses Intropaste to clearly define the horn wall.
- Dr. Redden advises that the foot should be placed so that it sits on the edge of the block touching the cassette. The alignment of the foot should be so that the line formed by the center of the heel and center of the toe run parallel to the long vertical cross hair. Ideally the short horizonal cross hair runs center of the foot and gives you a direct line to follow for your x-ray beam. Note: If the horse toes in or toes out, set your block accordingly to get an optimal shot.
- The rubber or plastic cassette holder on the side of the blocks helps assure zero film subject distance, prevents unwarranted radiation exposure and eliminates film movement.
NR–1 Measurements
Height: 3 1/2 inches (88.9mm)
Width: 6 7/16 inches (163.5mm)
Length: 9 inches (228.6mm)
Compatible for HF 80, HF 80+, HF 100/30 and any x-ray units that have a primary beam height of 4 to 4 1/4 inches (101.6mm - 107.95mm).
We make custom blocks upon request. To determine the block you need, simply measure the center beam height of your unit and subtract 3/4 of an inch (19.05mm) for block height.
Please choose the thickness of your cassette slot below.
Most standard cassettes measure 5/8 inch (16.125mm) and most vinyl/floppy cassettes measure 7/8 inch (22.225mm).
E-mail a friend about this item.