![]() |
![]() |
Vettec Superfast 20cc Cartridge
Cartridge Preparation
2. Before attaching the mixing tip, equalize the cartridge by squeezing out a small amount to ensure that both sides are dispensing evenly. Attach a mixing tip by pressing and twisting clockwise. 3. When finished, do not release the pressure with the lever on the back of the dispenser. Remove the mixing tip immediately, discard, and replace the cap. The pressure can now be released. Extra Caps can purchased. 4. For additional applications, re-equalize the cartridge, and attach a new tip. Hoof Preparation
2. DRY HOOF THOROUGHLY using a heat gun or hair dryer. Do not overheat. Note About Cleaning: Only if hoof is oily, wipe the affected areas with a cloth moistened with DENATURED ALCOHOL being careful not to saturate the hoof. Dry thoroughly. DO NOT USE ACETONE! Cold Conditions (Below 65° F) Failure to keep the hooves, shoes, and Super Fast warm will dramatically slow the cure time. (Example: At 32 degrees F the cure time advances 7 - 8 minutes.) Store the cartridges in an insulated “cooler” warmed with microwaveable heat pads or 1 to 2 tightly capped gallon jugs filled with hot water. In freezing temperatures, 32 degrees F or less, the shoes must be warmed to keep condensation from forming on them and preventing the bond. Hot Conditions (Above 85° F) Super Fast will set very quickly. To retard the set time, store the material in an insulated cooler with 1 or 2 freezer packs. * 2 Mixing tips included
Try these related products: E-mail a friend about this item. |
|










